Hi there all !
It's been a long time!
Having downloaded the latest ISO of alpine (
I came across this
iface bond0 inet manual
bond-slaves eth2 eth3 eth4
iface bond0.13 inet static
iface bond0.13 inet6 static
Will always give me
vconfig: ioctl error for add: File exists
at boot time
then trying to ifdown bond0.13 from command line will complain about
bond0.13 not being configured
needless to say ... when I've tried the same with vlan13 Naming
problems were almost the same
iface vlan13 inet static
iface vlan13 inet6 static
pre-up echo 0 > /proc/sys/net/ipv6/conf/vlan13/accept_ra
ifup vlan13 will give
run-parts: /etc/network/if-pre-up.d/vlan: exit status 1
and the ipv4 part being configured and ipv6 not, leaving the state of
vlan13 all messed up .. :(
Your ideas will be appreciated !
Received on Thu Nov 03 2016 - 04:49:48 UTC